There are many times when I need a helping hand for straight pins and having two little active girls at my feet I can't have a standard pin cushion because small hands get into so many things.
Two nights ago I took a scrap that I had made a month ago and added some elastic took me less than 10 minutes. It is a little loose because I didn't measure the elastic correctly and the first one always comes out wonky.
What you will need for this project:
1. Two pieces of scrap material 8 inches long by 4 inches wide
2. One piece of scrap interfacing or batting (thickness is up to you) with the same measurement as above
3. One piece of elastic (I have the 1 and 1/4 inch pictured above) this measurement isn't precise due to it needing to fit your wrist. Just make sure to make the elastic is not cutting off your blood supply when you put it on!
4. Thread, Sewing Machine and pins
Start by making a sandwich of the cut scraps and interfacing making sure that the two scrap patterns are facing each other and the interfacing is on top of one of the pieces of material.
Pin it in place and then sew with a 1/4 inch seam around the piece leaving a 2 inch gap on one side of the long side denoting by two pins where to start and finish. Back stitch a bit to lock the stitches in and clip the corners and turn out and iron down the sandwich for the nice edge and seam for the top stitch.
Next top stitch the sandwich closed.
Wait wait I hear you are saying "what about the elastic?" I am getting to that point so hold on.
With the sandwich closed fold it half the long way and add the elastic and pin it to the sandwich ends and sew the elastic to the ends and back stitch (the first end will be easier than the second end).
If you want you could close the open side, however I left mine open so I could have some where to stash a safety pin or two.